Instructions: PVR Paint & Varnish Remover

Mötsenböcker’s Lift Off (MLO) Paint & Varnish Remover is the World’s First Water-Based, Biodegradable, EPA Compliant Low/No VOC, Green Cross Certified, and Non-Flammable stripper for solvent and water-based paints, varnishes and lacquers from WOOD, METAL and STONE. MLO Paint & Varnish Remover can be used to strip most coatings from: WOOD, METAL and STONE.

 

Basic Prep Instructions:
Prior to stripping, you should prepare and protect the surrounding areas such as furniture, cabinets, and floors. When stripping furniture, protect the floors and walls with quality tape and plastic. For cabinets, remove hardware from the doors, protect walls, floors, and areas not to be stripped using quality tape and plastic. For floors,remove or mask off base moldings to protect these areas and the walls from stripper.

 

Basic Use Instructions:
For Flat or Smooth Surfaces: 1. Pour desired amount into a plastic container. 2. Use paintbrush to apply a liberal amount of MLO Paint & Varnish Remover in an area size up to 5’x5’. 3. Wait at least 5-10 minutes for gel to penetrate the coating. 4. Using a scraper, putty knife, or stripping pad, strip the surface in the same direction as the grain of the wood to remove the loosened coating from the surface. 5. Repeat steps as necessary for removing excessive coats or deeply ingrained stains.

 

For Rolled or Carved Surfaces:
Use stripping pad after following steps 1 and 2 above.

 

Final Step:
Once stripping is done: 1. Use warm water and stripping pad to remove all excess coating & MLO from surface. 2. Use warm water and clean towels to wash, rinse and dry surface. (Option: an alcohol rinse will enhance drying time and insure a clean and residue free surface). 3. Allow surface to dry completely up to 12 hours before refinishing.

 

Special Handling and Clean Up Instructions:
When using the stripper and removing coatings, the use of gloves and safety glasses are recommended as an added measure of safety. These will protect hands as product and stripped coating may dry out natural oils in the skin. Clean Up: Place stripped paint or varnish onto a plastic sheet and allow to dry for approximately 24 hours. Since the MLO Paint & Varnish Remover is a water-based and biodegradable formula, once it has completely evaporated, the dry residue is considered inert and non-hazardous and may be disposed of safely in a trash can according to local regulations.

 

Be cautious with use on concrete, test on an inconspicuous area first.

CAUTION: HARMFUL IF SWALLOWED. EYE AND SKIN IRRITANT.

Avoid contact with eyes and skin. For eye contact, flush with water for at least 15 minutes. Obtain medical attention. For skin, contact, wash thoroughly with soap and water. Do not ingest. If swallowed, do not induce vomiting. Immediately call a physician.

SHAKE WELL BEFORE USE • DO NOT FREEZE
KEEP OUT OF REACH OF CHILDREN AND PETS


The warranty for this quality-tested product is limited to purchase price.
No other guarantee is furnished or implied.